Wrought Iron Chair Glide Protectors - 16pcs 1-1/2" Diameter Furniture Leg Caps for Outdoor Patio Tables & Chairs - Durable Replacement Accessories to Protect Floors & Decks - Perfect for Backyard, Garden, and Poolside Furniture

How to Install Wrought Iron Chair Glides 1.You need to remove the old cap. You can do this by inserting a flat-head screwdriver into the gap to prise it out. You might need to tap it a few times but it should pop out fairly easily. In order to get a snug fit for your replacement chair glides, use a plier to pry in the metal in 2 or 3 places. This will mean your replacement glides will fit better and won’t fall out easily. Next, put the new glide into position and hold. You will need to tap it into the casing with a mallet. This might be a little difficult but this is what you want because you want it to be a tight fit. If you really can’t get the new caps in, we have a handy trick up our sleeves! You can boil them briefly in hot water. This will soften them up meaning that they’re easier to fit! Remove the old patio furniture glide Typically this is done just using a screwdriver you can pry into the gap and pry it off sometimes you'll see the old ring of part of the insert left over inside. You need to make sure that this hole is completely clean before you do any measuring so a lot of times that little ring you can just simply pry out of there.Then another common problem is the metal - if the cap has not been replaced and has worn into the hole it make it look like a smaller hole than it actually is. So if you do see metal worn into the hole take a flat head screwdriver and scrape that out of there so that you make sure you order the correct size first time so that you don't have to send them back in exchange or anything. Measure the diameter of the foot We want to measure the inside diameter of the hole from the inside edge to the other inside edge and that will give us the correct size.

Wrought iron chair glides fit into the "cup" area of your outdoor furniture feet with a inside diameter of 1-1/2". Please measure your inside diameter before you purchase the correct size.

Very thicker than the standard, keep the floors protected, provide the much-needed cushion to protect your floors from permanent damage. say goodbye to nasty scratches on your patio floors.

Perfect alternative to the Forever Glides, no need adhesive to stay in so these last longer, easy installed using a rubber mallet. Not have to replace it as often.

Perfectly fit the leg of most patio chairs and stools (1.5”) and prevent moisture build-up that may cause rust on your wrought iron tables or chairs.

16 pcs of patio chair glides is enough for 4 chairs (with 4 legs each). These durable leg cushions will last for seasons to come.